您好,欢迎光临山东银叶环保科技有限公司官方网站!

催化燃烧设备电气设备的处理应该注意什么?

来源:http://www.yinyehuanbao.com     发布时间:2021-01-13   浏览次数:

系统概述 本工程系统控制操作人员在工作室内进行整套工艺系统的运行参数设置监控,实现对本系统的启停,本系统可独立运行。
System overview the project system control operators in the studio for the whole set of process system operation parameter setting monitoring, realize the start and stop of the system, the system can run independently.
设计依据 低压配电设计规范(GB50054-95) 通用用电设备配电设计规范(GB50055-93) 建筑物防雷设计规范(GB50057-94)
The design is based on code for design of low voltage power distribution (GB 50054-95), code for design of power distribution of general electrical equipment (GB 50055-93) and code for design of lightning protection of buildings (GB 50057-94)
设计特点 电气控制系统主要由电器控制柜及管线架等组成。 l 电器控制柜采用PLC自动控制,同时也可手动操作。实现电源控制风量调节温度自动控制保温时间自动控制(2小时)故障报警装置等。
Design features the electrical control system is mainly composed of electrical control cabinet and pipeline frame. The electric control cabinet adopts PLC automatic control, and can also be operated manually. Realize power control, air volume adjustment, temperature automatic control, heat preservation time automatic control (maximum 2 hours), fault alarm device, etc.
电器控制设置自动操作档和手动操作档。
Electrical control set automatic operation gear and manual operation gear.
电器控制柜面板上设置电流和电压表数显仪表温度调控器,吸附时间调控器及风机加热器照明等指示灯按钮。  l 电器控制柜自动工作时,都是预先根据设备所需功能编程好的,操作时只要把开关旋转到自动档,设定所需温度及烘干时间,按下指示按钮即可。这时风机根据程序自动间隔约3秒相继启动工作,接着加热器自动相继间隔工作。停止工作时,加热器先自动停止工作,约间隔5分钟后风机自动停止工作。
催化燃烧设备
The panel of electrical control cabinet is equipped with current and voltmeter digital display instrument, temperature regulator, adsorption time regulator, fan heater lighting and other indicator buttons. When the electrical control cabinet works automatically, it is programmed in advance according to the required functions of the equipment. During operation, just turn the switch to the automatic gear, set the required temperature and drying time, and press the indicator button. At this time, according to the program, the fan automatically starts to work at an interval of about 3 seconds, and then the heater automatically starts to work at an interval. When it stops working, the heater will stop working automatically first, and the fan will stop working automatically after about 5 minutes.
电器控制设备都是互锁的。电器控制柜设置故障声光报警,如果风机出现故障不运转或加热器出现故障等,只要那一个环节出现故障,都能自动切断总电源,自动停机声光报警。
Electrical control equipment is interlocked. The electrical control cabinet is equipped with sound and light alarm. If the fan fails to operate or the heater fails, as long as there is a failure in that link, it can automatically cut off the main power supply and stop the machine automatically.
在设定温度后,加热器自动工作,温度达到后自动断电,并能在保温时间内自动加热保温。有故障后,能自动停电,确保安全。加热时,风机先工作,到设定时间后加热器自动工作。停止加热时,加热器自动断电,到设定时间后风机自动停止工作,确保安全运行生产。 l 电器控制柜内主要元器件为进口产品如ABB施耐德等品牌。
After setting the temperature, the heater will work automatically. When the temperature reaches, the power will be cut off automatically, and it can heat and keep warm automatically within the holding time. In case of failure, it can cut off power automatically to ensure safety. When heating, the fan works first, and the heater works automatically after the set time. When the heating is stopped, the heater will be cut off automatically, and the fan will stop working automatically after the set time to ensure the safe operation and production. L the main components in the electrical control cabinet are imported products, such as abb Schneider and other brands.
负荷等级 本有机废气·吸附催化燃烧装置配电电压等级380V/220V,三相四线制,控制电源为交流220V。 电气设备选择在满足工艺要求及确保人身安全的前提下,程 度的选用操作方便可靠性高便于维护半自动化程度高的设备,以便使整个电气系统可靠的运行
Load level: the power distribution voltage of organic waste gas adsorption catalytic combustion device is 380V / 220V, three-phase four wire system, and the control power supply is AC 220V. On the premise of meeting the process requirements and ensuring personal safety, the electrical equipment should be selected with convenient operation, high reliability, easy maintenance and high degree of semi automation, so as to make the whole electrical system run efficiently and reliably
本文来自:催化燃烧设备更多的内容请点击:http://www.yinyehuanbao.com我们将会为您提问的问题提供一个满意的服务,欢迎您的来电!
This article is from: catalytic combustion equipment. For more information, please click: http://www.yinyehuanbao.com We will provide a satisfactory service for your questions, welcome your call!

上一篇:除尘器出现结露现象的处理方式有哪些?
下一篇:最后一页